A satellite dish install is not always for the do-it yourselfer, some should consider a professional installer. Many satellite retailers offer a free installation with a new subscription. If you decide to install the satellite dish yourself, here are a few useful tips.
Here is a list of necessary items before getting started: atellite signal finder, complete satellite system, RG6 coax cable, 7/16″ wrench, nut driver bit, cable ties or black tape, staples or screw clips, mast level, lag bolts and compass.
Begin by identifying a suitable location for the satellite dish. The install location should have a clear line of site and be able face the direction as determined by your zip code. Quality line of sight is paramount, for any interference may hinder adequate signal strength. Another important task is to bolt the mast firmly and ensure it is plumb in all directions. Depending on the install location, you may use the provided foot / mast assembly. Many installers prefer a satellite tripod or other alternatives, depending on the situation.
The next step is to secure the satellite dish placed on the mast, but do not tighten the bolts. Put the coax cable through the arm of the satellite dish where the LNBF is and then properly connect the coax cable. Then be sure to secure the LNBF to the satellite dish. Do not over tighten the bolts. Now review the satellite system's manual for guidance on the correct elevation and skew of the dish. The user manual should provide detailed measurements based on your zip code. The satellite dish should include tick marks to accurately set the measurements.
Connect the coax cable to the satellite signal finder and also consider using the television for signal confirmation. Once you set the satellite dish measurements, then check the satellite signal finder until the signal is located. Make horizontal / vertical adjustments to the reflector as needed to peak the signal. After achieving an peaked satellite signal, secure the bolts on the satellite dish.
Make the coax cable connection from the satellite dish to the receiver. Finally, perform the final test by connecting the receiver to your television. There may be a few confirmation steps to follow on-screen to complete the satellite dish installation. Once that is complete, you are ready to watch your favorite show.
Article Source: http://www.articlesbase.com/cable-and-satellite-tv-articles/how-to-install-a-satellite-dish-4145021.html
About the AuthorI am the co-founder of PLDepot.com and AdvantageMeters.com, both are leading resources of Satellite Meters, Labor Saving Devices, Satellite / Cable Installation Tools and Accessories. I am also a partner of Bounce10.com, an experienced provider of enterprise-level eCommerce solutions.